Author Topic: Tsas warning 1/1  (Read 805 times)

0 Members and 1 Guest are viewing this topic.

Online Bruce Wayne

  • Explorer Pro
  • ***
  • Topic Author
  • Posts: 350
  • Bike: Tiger 1200 XCA
  • City / Town: Winterswijk
  • Country: nl
Tsas warning 1/1
on: March 07, 2022, 01:51:22 PM
Hi there fellow tigers,
I need some  assistance for my XCA 2018. When I start my bike, and it’s calibrating my mode setting, there is over time a warning message. It says 1/1 TSAS warning. Now either I’m blind and need a Manuel in breille or it is not in the book.

Can anybody of you tell me how to see what this warning is and how to delete it?
I tried already the calibration methode beeing;
1. Put the power switch on, and wait Utility all blinking lights are of.
2. Then start the bike and wait again.
I understudy it should erase warnings l if calibration is done.
But neither of them 2 helped to delete the message. Is this something only the dealer can do?

Txs in advance.

Bert

#1

Offline XCaTel

  • Explorer God
  • *****
  • Posts: 2706
  • Bike: 2018 XCa
  • City / Town: County Kildare
  • Country: ie
Re: Tsas warning 1/1
Reply #1 on: March 07, 2022, 04:51:27 PM
When it happened to mine I had to get the dealer to reset it, it was a simple job for them. You might like to disconnect the battery and leave it for 10 minutes then reconnect and try powering up normally again. Disconnecting the battery can force a calibration.

#2

Online Bruce Wayne

  • Explorer Pro
  • ***
  • Topic Author
  • Posts: 350
  • Bike: Tiger 1200 XCA
  • City / Town: Winterswijk
  • Country: nl
Re: Tsas warning 1/1
Reply #2 on: March 08, 2022, 11:26:51 AM
*Originally Posted by XCaTel [+]
When it happened to mine I had to get the dealer to reset it, it was a simple job for them. You might like to disconnect the battery and leave it for 10 minutes then reconnect and try powering up normally again. Disconnecting the battery can force a calibration.

txs for your reply. I'll try that when a get back home.

#3

Offline Hawkeye

  • Explorer Master
  • ****
  • Posts: 974
  • Bike: XRx Low (Sold)
  • City / Town: Billericay
  • Country: england
Re: Tsas warning 1/1
Reply #3 on: March 08, 2022, 03:26:47 PM
It could also be low battery voltage whilst calibration is taking place.

#4

Offline TigerOnTrail

  • Explorer Junior
  • *
  • Posts: 2
  • Bike: Tiger 1200 2019
  • City / Town: Bengaluru
  • Country: in
Re: Tsas warning 1/1
Reply #4 on: May 26, 2022, 03:26:25 AM
*Originally Posted by Bruce Wayne [+]
txs for your reply. I'll try that when a get back home.

Hello Bruce, how did you finally get it cleared?

#5

Online Bruce Wayne

  • Explorer Pro
  • ***
  • Topic Author
  • Posts: 350
  • Bike: Tiger 1200 XCA
  • City / Town: Winterswijk
  • Country: nl
Re: Tsas warning 1/1
Reply #5 on: May 26, 2022, 05:09:14 PM
*Originally Posted by TigerOnTrail [+]
Hello Bruce, how did you finally get it cleared?

Hello TigerOnTrail,
Unfortunatly not yet cleared. The dealer looked at it and mentioned it needed some more investigation.
They didn’t cleared the warning either.
I still need to try the disconnecting methode of the battery. Didn’t had time to this.

#6

Offline TigerOnTrail

  • Explorer Junior
  • *
  • Posts: 2
  • Bike: Tiger 1200 2019
  • City / Town: Bengaluru
  • Country: in
Re: Tsas warning 1/1
Reply #6 on: May 26, 2022, 06:39:26 PM
*Originally Posted by Bruce Wayne [+]
Hello TigerOnTrail,
Unfortunatly not yet cleared. The dealer looked at it and mentioned it needed some more investigation.
They didn’t cleared the warning either.
I still need to try the disconnecting methode of the battery. Didn’t had time to this.

Thanks for response. I have left my 1200 with the service centre today. He tried reloading the firmware and battery disconnection. But the warning didnt go. The system said there is a potential issue with front solenoid.
He said he needs time to inspect various points of connectivity and then confirm if something is really wrong.